Step method for trimming the end face of the cutting piece

1. Install the cutting piece in the hole perpendicular to the axis on the round bar of the wheel dresser, adjust the position of the round bar of the dresser trimer, make the diamond tip lower than the center of the grinding plate 1-2mm, and fasten the bracket. 2. The hand grinder table is fed longitudinally to the hand wheel to bring the diamond close to the end face of the plate. 3. After the diamond is in contact with the end surface of the grinding plate, the longitudinal feeding of the table is stopped, and the hand-shake frame is fed laterally to the hand wheel, so that the diamond reciprocates back and forth on the end face of the grinding plate. After multiple feeding and trimming, the end surface of the grinding disc is ground into a concave plane, and the edge of the transmission line of the thin flat cutting disc is left with a clamping edge of H=3 mm. Pay attention to the correction of the cutting piece: 1. Pay attention to the rigidity of the diamond rod to prevent the diamond from vibrating during correction. 2. When the correction is made, the manual feed of the table should be slow, and pay attention to the width of the control clip. 3. Generally, the end face of the grinding wheel should be trimmed first, and then the circumferential surface of the 12 inches cut off wheel should be trimmed. The cutting piece industry is developing rapidly, and the market is a blending agent that caters to the customer experience and continuously deepens the change strategy in order to adapt to the market. It is not difficult to see through the information released by the report of the 18th National Congress that accelerating the pace of industrial upgrading by strengthening environmental protection construction, promoting energy conservation and emission reduction and ecological environmental protection will be the key tasks of the country for optimizing industrial development, and will continue to persist for a long time. For the cutting chip industry, upgrading and transformation will also be in line with the country's development direction and in line with the industry's improvement. After decades of high-speed and extensive development, the cutting blade industry has left many negative consequences in the market and ecological environment. As the state strengthens the supervision of energy conservation and emission reduction, it gradually accelerates the pace of eliminating backward production capacity, which will usher in new challenges for the cutting chip industry. At the 18th National Congress that ended not long ago, it was clearly pointed out that it is necessary to promote the strategic adjustment of the economic structure. Promote the healthy development of strategic emerging industries and advanced manufacturing industries, and accelerate the transformation and upgrading of traditional industries. It must be mentioned that the report of the 18th National Congress first proposed the concept of “ecological civilization”, which included environmental protection, resource conservation, energy conservation, development of renewable energy, water, atmosphere, soil pollution control, etc. A strong focus on environmental protection, resource recycling, energy conservation and emission reduction and other related areas of the signal.

asdfasda asdf asd a fas a as a asd a fas...